Best results will be obtained when the hanging surface is mirror smooth.
Can be installed either vertically (use a plumb line) or horizontally (use a level line), though horizontal is recommended. Although seams can be written over, we suggest keeping seams out the major writing and viewing areas (80-230cm from the floor). In this way we would suggest hanging a half-width strip - cut left to right along the length of the material - followed by a full width strip in the middle of the wall followed by another half strip. Be sure to reverse every other strip regardless of vertical or horizontal installation method. Paste either wall or back of material, ensuring edges are well pasted. Re-paste any areas if there is a delay in hanging. Use a rounded spatula to smooth the Walltalkers to the wall. Reverse hang each alternate length, overlap and double cut through with a sharp blade. Change blade for each length. Smooth from the middle to the outside edge. Be sure to remove excess adhesive. Do not stretch material to butt seams - slide the entire length. Be careful not to crease the Walltalkers material when handling. Do not puncture air bubbles and do not use metal or sharp objects (other than the cutting knife) on the surface when installing the material.