TECHNICAL SPECIFICATION

Express Walltalkers WriteOn/ProjectOn
Description
 Low sheen, matt white dry erase marker surface. Primarily intended as a writing surface, but can also be projected onto.
Delivery
 Express 24 Hours.
Roll Width
 151cm
Weight
 731 grammes per square metre
Fire Rating
 Class 0 and 1 to BS476 part 6 and 7 when applied to a suitable substrate.
Adhesive
 Tekfix VOV
Hanging
 Can be installed either vertically (use a plumb line) or horizontally (use a level line), though horizontal is recommended. Although seams can be written over, we suggest keeping seams out the major writing and viewing areas (80-230cm from the floor). Be sure to reverse every other strip regardless of vertical or horizontal installation method. Paste wall , ensuring edges are well pasted. Re-paste any areas if there is a delay in hanging. Use a rounded spatula, covered in a damp cloth to smooth the Walltalkers to the wall. Reverse hang each alternate length, overlap and double cut through with a sharp blade. Change blade for each length. Smooth from the middle to the outside edge. Be sure to remove excess adhesive. Do not stretch material to butt seams - slide the entire length. Be careful not to crease the Walltalkers material when handling. Do not puncture air bubbles and do not use metal or sharp objects (other than the cutting knife) on the surface when installing the material.
Maintenance
 Use either Walltalkers or Sanford Expo dry erase markers for best results. Remove dry-erase markings with Sanford felt eraser for longer lasting surface effectiveness. Press firmly when erasing, using a circular motion. Change erasers as they become dirty - dirty erasers leave excess ink on the surface. For daily cleaning, or as required (to remove ‘ghosting’ marks etc.), spray surface sparingly with Sanford Dry Erase cleaner and clean with either a soft absorbent cloth or absorbent paper towels. Rinse thoroughly. If the Write/project On is in constant use, a daily clean with the cleaner followed by rinsing with water will help retain its original appearance.
Health & Safety
 This product is classified as non-hazardous and therefore does not require any special handling. This product does not require special labelling.
Handling/Storage
 Store at ambient temperatures away from heat source. Suitable lifting equipment may be required.
Fire Fighting
 Any extinguishing media are suitable. Wear self contained breathing apparatus, protective clothing and full face mask. Fumes should be ventilated immediately due to possible liberation of noxious gases.
Ecological
 This product is not bio-degradable. Dispose of in accordance with Local Authority regulations or via an authorised contractor.